Recent content by Blake

Does the old shake the tire trick on these work to check for play?

Looks like the bearings are sold separately, can I reuse the hubs?

Hey guys! I have a 00 4x4 and I believe my front bearings are shot. Trucks got 212k on it and I can hear them kind of making a small skreeching sound. Can I just buy the hub and bearing assy’s, throw them on and roll? If you guys could give me some insight that would be great! Blake

Struts are fairly new, I’ll report back later today after work. Maybe they just need to be greased up?

Hey guys. I haven’t been on the site in a while. I have a 2000 trd, with all new upper and lower ball joints, and sway bar end links. I was going to put in new sway bar bushings but the ones I got were too small and maybe for a 2 wheel drive. My truck has a squeak type sound when turning...

What is the factory recommended guide lines??

I had an Airaid on my 2000 v6, I liked it, I ended up taking it off because the noise just got a little to much for me. Really didn't notice any performance improvement. Sounded cool though.

That happened to me on my 2000 trd. I drove it for a few miles and it went away.

Where would I look on my truck for the frame rust issue? I've kept my eye on it and don't see any. Any specific areas?

Aftermarket air filters I mean

Watch out with air filters on 3.4L's, they don't like em much. Check engine light city!

How often do you guys change your trans fluid on your first gen tacomas?

Thanks, I can't find my Haynes manual. Probably a coil pack, I'm assuming.

Which cylinder is number 3 on a 2000 Tacoma 3.4 liter? I have a cylinder 3 misfire?