nickmccurley
Member
I am putting a 3 inch lift on my truck. Wondering if a 20x10 -24 offset wheel will be ok?
2015 tacoma lift and wheels
- Thread starter nickmccurley
- Start date
OR17TRD
Well-Known Member
Should be ok. Be ready to do some wheel well modification ie. trimming and molding though. Pictures.
Welcome to the forum.
285/55/20 tires would be best.
nickmccurley
Member
I was planning on 275 55 20
nickmccurley
Member
What lift do you think would be better 4" spindles? Or a 3 inch rough country lift and level with longer front coilovers? I'm trying not to have to buy new ucas so I was thinking maybe spindle lift?
OR17TRD
Well-Known Member
You have a prerunner?
OR17TRD
Well-Known Member
Those will be close to the same width as your 10” wide wheels. Not much strength on the bead at that point. Something to consider.
nickmccurley
Member
Yes.
nickmccurley
Member
Still wondering if I should go with spindle lift or longer coilovers in the front?
whippersnapper02
Negative Nancy
Spindles. The normal coilovers you can buy are not longer.
Last edited:
nickmccurley
Member
I was going to go with a 3inch coilover setup. But I'm thinking with spindles I shouldn't have to get new ucas
whippersnapper02
Negative Nancy
No uppers needed with spindles unless you get adjustable coilovers as well and crank them.
nickmccurley
Member
What about like a 3 inch rough country lift that has new front coilover that use the stock front spring.. would you need new ucas with that some say yes and no
whippersnapper02
Negative Nancy
More than likely yes because you won't be able to get the alignment correct. Stay away from anything from Junk Country though.
nickmccurley
Member
Do you have any info on what shock would work in the rear with a 2 inch lift
whippersnapper02
Negative Nancy
5100s or OME.
nickmccurley
Member
I was thinking about 4 inch spindles in front with adjustable 5100s. And 2 inch lift in rear.
whippersnapper02
Negative Nancy
If you leave the front 5100 coilovers in a low or no lift setting, you will be fine and it will ride smooth. If you crank them for max lift, the ride will be harsh and you will need those uppers. I'd leave them at 0 and just run the lift from the spindle.
nickmccurley
Member
Yeah that's what I was thinking I'm looking for a smooth ride. Thanks for the help
OR17TRD
Well-Known Member
You’re welcome
15'TSS
Member
I have 2.5inch lift with 18x10 -24 and 285/65 and only did minor plastic trimming