Discussion in 'General Tacoma Discussion' started by tommyboy, Mar 14, 2017.
What will happen if I unplug this sensor? Will it just through a abs light?
Join TacomaForum.com Today!
You would probably get a CEL, ABS and TRAC light. Are you trying to eliminate it or just move it out of the way for a sec?
To eliminate it
Not going to happen without a christmas tree in your dash.
Ok shoot, my abs acts up on my 2012
Did you lift and not reset the VSC parameters? The dealer can do it but they will charge you.
Yea it's done it ever since I lifted it I brought it into the dealer they told me they could do nothing about it, they told me to put it back to stock and it will be fine
Screw the dealer.
There is a thread on TW that tells all about it. Easy.
You can always just turn VSC off before driving.
I've tried that still does I grounded out a wire to a switch when I wheel it doesn't do it at all
Is that with the graphs?
If you take it back or do it yourself make sure your truck is on level ground and the steering wheel is straight.
It's a step by step on how to reset your VSC settings. I didn't see any graphs. It's a good write up and real easy to follow.
Thanks this is a different one then I saw before
I just reset my VSC setting today. Pretty easy job. Hardest part was getting my old eyes in position to see the damn terminals.
Yea I did it today too seemed like it has fixed it only time will tell
Is this the same for the 2016 and 2017?
Not sure at all on that. Someone will know tho...
Separate names with a comma.