Undercoating

JayQQ97 said:
yeah my tools sockets other sh!!T all gummied up with black woolWax residue o_O o_O o_O
it is a messy
you have valid prohibition most definitely
just put'em in a solvent bath ??
Click to expand...
Power wash them in a bucket while adding some simple green fed into it.
 
Well, opinions from others might see it differently.,..just saying:rolleyes: I know this is difficult for those of you under 10 years old, but this is the maintenance section for an undercoating thread. Be nice to keep things on track.
 
Last edited:
brushed sum cosmoline on the gen2 passenger side a couple weeks ago when it was 90 degrees out

it look nice after the tarcoating was removed
 
Cosmoline holds up best on a new vehicle chassis as long as at least two coats are applied. Found crc, not quite as good as that rp-342 cosmoline.
 
When applying straight cosmoline like that, it needs to be thinned down so it creeps into all crevices like rp-342, or the crc marine heavy duty corrosion inhibitor.
 
Gotta get a wand, and spray the frame insides...thats how they begin to rust through with these tacoma's. I remember it being a real messy job on my gen3.
 
i sprayed other anti-salt stuff from canada inside there that is super fluid wont dry and only drips when it hot AF out
drips out that tailgate!!!
 
do the gen3 get all this NASTY saltspray inside the engine compartment?

this gen2 it comes in from the tires splashing all over the place :confused:
 
You must log in or register to reply here.
Back
Top