2016 Toyota Tacoma 2 inch lift kit

[Normand]

Do you need to do anything to the front end putting on Bilstein shocks with block for the back

 

[whippersnapper02]

It will stink bug.

 

[Normand]

It will stink bug.

thanks

 

[Ryan Williams]

No, you should be good to go.

 

[whippersnapper02]

thanks for nothing

I’m guessing you didn’t understand. The truck will be ass high if you lift it 2 inches in the rear.

Your question makes no sense.

 

[Normand]

I’m guessing you didn’t understand. The truck will be ass high if you lift it 2 inches in the rear.

Your question makes no sense.

I’m guessing you didn’t understand. The truck will be ass high if you lift it 2 inches in the rear.

Your question makes no sense.

The front shocks will raise the front of the truck two inches new shocks all the way around

 

[whippersnapper02]

The front shocks will raise the front of the truck two inches new shocks all the way around

You didn’t mention anything about front shocks before. It was just rear blocks and shocks.

What are you trying to ask?

 

[Normand]

You didn’t mention anything about fron shocks before. It was just rear blocks and shocks.

What are you trying to ask?[/QUOTE If I need to do any front end work putting on this lift

 

[whippersnapper02]

So a lift all around? Not just the rear? No, just put it on.

 

[Scuzzy]

Assuming you are 2” front lift as well, DO NOT use lift blocks in the back. Add a leaf or purchase a 2” lift spring pack. Add a leaf will squeak a bit as the suspension flexes, a properly built new spring pack will not. Blocks torque the springs and will eventually fail, require constant retorquing of the bolts and cause much wear on the drivetrain. Add a leaf costs the same and required the same labor to install. IMO.

 

[Normand]

Thank you that's why I ask I will look in the getting the leaf springs and yes Blistin shocks all the way around and the 1.5 leaf for the back