Driveshaft

B

Bin72

Member
Got a question. Need to know how to balance the driveshaft after u replace the u- joints. Forgot to mark it
 
Crawdad said:
Are you referring to marking the flanges closest to the rear axle before separating? Could rotate around to see if the dirt kinda matches in an area? If you really can't tell, take your best guess and sleep well because it really isn't a big issue.

Hope that helped?
Click to expand...
Thanks. Haha
 
Bin72 said:
Yeah I know that's why I did. U don't have to be a smartass though. I take my truck serious.
Click to expand...
I was being serious about thanking you for letting us know. Most people would have just never said anything and left us hanging until one of us said hey @Bin72 did you ever figure out your shaft?
You may or may not have replied at that point and we would have all been concerned about you.
But yes I am a smartass. :oops:
 
Ok dude. I'm sorry I took it wrong. Thanks for the concern. And don't worry about being a smartass I'm the whole ass sometimes.
 
Bin72 said:
I had to play with it for a little while but I finally got it to line up. Now she drives better than before.
Click to expand...

OR17TRD said:
She’s all greased up and ready to go. :D
Click to expand...

Crawdad said:
So what were you asking? We still don't know... haha

I was concerned enough to ponder on it a while and I gaurantee @OR17TRD was too. We all have elevated gluteus maximus IQ's around here... [emoji13]
Click to expand...

I just skimmed through this thread but what I got from it was: @Bin72 had questions about his shaft and where to put it. @OR17TRD greased up the shaft and it’s ready to go. And @Crawdad is talking about his gluteus maximus.
This sounds like you guys may need to take this to a private message. This is a family site.
 
You must log in or register to reply here.
Back
Top