Lift tires gears

C

calebfulmer

Member
I am wanting to lift my 2011 Tacoma trd. I have thought about 35s. I know when I went to 35s and then 37s on my diesel I had no problems power wise. With the v6 Tacoma does anyone on here have an advice on how high I will have to lift it to clear 35s at full compression and what gears would be needed to pull them comfortably?
 
calebfulmer said:
I am wanting to lift my 2011 Tacoma trd. I have thought about 35s. I know when I went to 35s and then 37s on my diesel I had no problems power wise. With the v6 Tacoma does anyone on here have an advice on how high I will have to lift it to clear 35s at full compression and what gears would be needed to pull them comfortably?
Click to expand...
Well as far as I know, yes if your putting 35's on your Tacoma YOU NEED TO REGEAR. some people don't but they'll regret it when their tranny gives out. As for the lift 6 in is usually recommended, but what I would do (and this is just me), I would do like a 3-4 in lift and add the 35's and kinda cut the fender to make it fit. I don't like my truck lifted more than 4 in personally. I think that'll just be a better look. But in short, yes re gear for 35's
 
I was thinking 6 to make sure they fit yes but I could trim a little to make them fit. Personally I like a smaller lift with tires that fill up the space I don't like 8 inch lift on 33s for for example. If you know what I mean
 
Also remember the higher the lift, the less center of gravity you'll have. And that is crucial when your off road.
 
You must log in or register to reply here.
Back
Top