It’s a Toyota Motor from a FWD car because it’s a VVTI 16 Valve. It could be a Camry, Corolla, Yaris, etc.
But it’s definitely not the motor for that truck. Lol.
Inferno LB coming along!
- Thread starter bumpedmyhead
- Start date
It’s a Toyota Motor from a FWD car because it’s a VVTI 16 Valve. It could be a Camry, Corolla, Yaris, etc.
But it’s definitely not the motor for that truck. Lol.
That’s a clean first gen. The interior doesn’t even look like it’s ever been sat in.
kp.taco
Well-Known Member
Haha no I got a HUGE yard.
kp.taco
Well-Known Member
Yes it definitely is. I didn't notice the mileage at first. Wow..
kp.taco
Well-Known Member
I want to facelift my 09 to the 12-15 front end. It's pretty easy to. Fenders are the same
bumpedmyhead
Well-Known Member
Stop hijacking my build thread! Anyhow....SR bezel came in today. Too damn hot to put it on. Gonna look better, IMO.
kp.taco
Well-Known Member
That's gonna look good
Dang. I’ve been on the fence about the SR bezel on my 18 Inferno. Now I might have to do it.
If I get one I’m telling my wife it’s your fault.
Oh, and threads get hijacked on this forum like Palestinians hijack planes. It’s gonna happen man. Lol.
bumpedmyhead
Well-Known Member
I know, just messin with ya
kp.taco
Well-Known Member
Just use plasti derp. Lol
Would be cheaper. I’m all about easier and permanent though. Lol
bumpedmyhead
Well-Known Member
Installed the SR black bezel. My gosh that was easy, took 30 mins. Half dozen tiny screws, a few clips, and voila! So much better IMO.
OR17TRD
Well-Known Member
I like that
Love it.
OR17TRD
Well-Known Member
You going to do it?
bumpedmyhead
Well-Known Member
Got the lamin-x on the new Morimoto XB fogs. Pain in the ass. Gonna take a little more finessing tomorrow. It just doesnt want to lay over these domed ovals. Oh well, get out the heat gun. 
Maybe........
Did you take the whole grille out I’m assuming
bumpedmyhead
Well-Known Member
Yes, its 2 clips and 2 10mm bolts. Unplug tss. Took 2 mins.