FS NEW QuikFix QF-SR1 6061 aluminum seat risers. FREE bolts and shipping.
mrproduxn
Well-Known Member
Note to buyers with sliders welded to your frame. A customer had to add a washer to each side of the driver seat. We were baffled. Finally figured out the welded slider on the driver side affected the threaded holes. Had no issue on the passenger side. This is the only issue found in over 30 pair sold. So if you have welded sliders, and you add spacers under the seat to floor brackets, you may need to pick up a pair of washers for the 10 mm bolts. This is info for any brand or style of seat spacers that you buy.
mrproduxn
Well-Known Member
PRICE DROP !!!!!!
I am down to the last pair of spacers. I have ordered material for the next run and the material prices have been reduced and I am passing the savings down the line. This last pair are discounted to deplete inventory and, as of now, the next batch will have these new lower prices. Same quality grade 6061 material and same grade 10.9 flange bolts. I expect to start production in the next 10 days with a release somewhere between May 15 and May 31. Note ebay prices are higher to cover fees. New member direct paypal prices are:
1 pair $35
I am down to the last pair of spacers. I have ordered material for the next run and the material prices have been reduced and I am passing the savings down the line. This last pair are discounted to deplete inventory and, as of now, the next batch will have these new lower prices. Same quality grade 6061 material and same grade 10.9 flange bolts. I expect to start production in the next 10 days with a release somewhere between May 15 and May 31. Note ebay prices are higher to cover fees. New member direct paypal prices are:
1 pair $35
Last edited:
mrproduxn
Well-Known Member
Managed to saw cut enough for around 50 pair today before the rain came. By requests the new version will look like picture 2 in a previous post. The angled parts "look" better but there is no other benefit and it just creates a lot more labor. More labor = higher price. I prefer to maintain a lower price.
mrproduxn
Well-Known Member
I got tied up pulling both fenders off a car today and that set me back a little bit.
There was no way I could get 50 pair finished on the mill, then drill all 50 pair on the mill, and have any ready to ship by tomorrow. So I dusted off the old floor drill press and have both machines going. The drilled holes may be 0.005" out of location but the holes are drilled to 11 mm for the 10 mm bolts (0.040" larger than the bolts). This is a non-issue. Anyone wanting pairs can now pm me for payment details. I am in the process of sending out a pm to those on the waiting list.
There was no way I could get 50 pair finished on the mill, then drill all 50 pair on the mill, and have any ready to ship by tomorrow. So I dusted off the old floor drill press and have both machines going. The drilled holes may be 0.005" out of location but the holes are drilled to 11 mm for the 10 mm bolts (0.040" larger than the bolts). This is a non-issue. Anyone wanting pairs can now pm me for payment details. I am in the process of sending out a pm to those on the waiting list. 
